-
I’m getting this issue (glitch no worky Check mosfet)
It then boots into the default dance OS. Was wondering if it’s my crappy soldering (probably this) or something else. I can provide photos of t…
-
I need an CPL file to order it on jlcpcb.com. Or could you explain what I need to set to order?
-
I accidentally bridged the caps, I thought my tip was small enough but it wasn't and I can't free them. Am I screwed? My thought is to remove them and buy new ones and place them on, but I can't measu…
-
## 75 Ohm Resistor (Any resistor between 50 and 150 ohms is okay)
> [!TIP]
> simulating load on one signal, without soldering, or any extra hardware. I simply insert the resistor —75 Ω is the ideal …
-
Hi All,
I'm getting ready to actually start 'using' my oven, instead of just playing with the firmware, LOL.
I made an eval type board for a BGA chip that is 388 pins, it's an STMicro chip from …
-
I bought and soldered all the pieces, was able to flash the firmware, and all looked good. But almost no key worked, and the ones that triggered a key press was doing it bad (on repeat, multiple chars…
-
I started assembling the keyboard today, I already assembled the right half, the left one is still not finished.
I plugged the assembled half of the keyboard to the computer, and entered vial, to tes…
-
-
Introduction
We have blank PCBs that have recently arrived from Advanced Circuits, and they need to be soldered. We have a couple for Dark Power, and 3 for the Flyback Cape. No need to solder all …
-
Hi! After looking at your detailed info I decided to try soldering on some connections to the two marked USB headers on the AD5M motherboard. Neither of them work and I am not sure why? I'm definitely…