-
Dear owner of the repository,
I'm using this library to interact with an SX1262, and I'm the author of another library that works with SX1276. The chip, by default, is put in continuous receiving m…
-
**Description.**
Is the LLCC68 supported? The github page says it is, but the [GithubIO page](https://jgromes.github.io/RadioLib/) doesn't list it under supported modules. If it really is, would it b…
-
Does the schematic here reflect the SX1262 version of the board? The markings just say "V1.1".
And please tell me which arduino.h file corresponds to this board. All the ones I seem to have refer …
-
**IMPORTANT: Before submitting an issue, please check the following:**
1. **Read [CONTRIBUTING.md](https://github.com/jgromes/RadioLib/blob/master/CONTRIBUTING.md)!** Issues that do not follow this d…
-
Hello! It has been a while since I bothered you.
I am attempting to help a Project Team that is having success with 1k2 FSK from an SX1268 module using RadioLib but we are not able to decode anyth…
K4KDR updated
2 years ago
-
My board is very simple - Arduino UNO chip and crystal with no regulator or serial interrace - battery powered. I made two changes to your transmit example without interrupts: pin assignments to mat…
-
Code runs OK with 5.3.0.
SX1262 radio = new Module(RADIOLIB_BUILTIN_MODULE);
.....
state = radio.begin(923.3,500.0,9,6,0x12,17,PREAMBLE_LENGTH,1.6,false);
Fails with 5.4.0; state = -707 (RADIOL…
-
I am trying to init LORA on a TTGO T-Beam ESP32 LORA. However, I keep getting -705. Is there something I am missing? Thanks for your help in advance.
#define SCK 5 // GPIO5 -- SX…
-
I was able to compile fine, but when I run:
sudo PORT=/dev/ttyUSB0 make flash
It looks like it's trying to flash the Evil Crow. Lights on it are blinking. Then, I get this: Any ideas what I'm do…
-
Hello Jan!
sorry for dumb question, but I carefully read all corresponded issues regarding CubeCell. FSK modem works great at SX1276+ESP32
But my problem is CubeCell at FSK mode. Can not pass ini…