-
with my ttgo-lora32-v21 iGate, yesterday I lost power and battery went down.
When Power recovered, the iGate started to send to APRS-IS server a lot of time the same device position even if it do not…
-
Hi,
I'm trying to use the library with a Dragino Lora GPS Hat v1.4 board on a RPi3, with no luck so far (assertion error in set_freq during calibration). Has anyone successfully used this board? Wi…
-
Riccardo, would it be possible to have a new prebuilt release for the web installer? There's been quite a lot of changes since April 16th :)
I have no idea how much extra work does this create on y…
-
Hi,
I am using SX1278 chip from AI-Thinker (433 MHz) with Arduino board to get the temperature and humidity data but I am getting "Starting LoRa failed". I made the changes as mentioned in this thr…
-
After flashing `TTGO ESP32 LORA - 868MHz, for USB-OTG with handset` firmware on a TTGO ESP32 LORA (using command provided in the readme) I have no feedback (oled black), serial port reply just with bo…
-
### Behaviour I observe
Looking at the frame counter of my device over a couple of days I see the following:
![image](https://user-images.githubusercontent.com/948278/99531346-404f0900-29ab-11eb…
-
Hello, and first of all, congratulations on this project which is working wonderfully.
Would it be possible to add a line of code to show that the USB is powered? (Same as internal battery voltage in…
-
### Board
M5Stack Core2
### Device Description
n.a.
### Hardware Configuration
n.a.
### Version
v2.0.14
### IDE Name
Arduino IDE / arduino-cli
### Operating System
Linux
### Flash frequenc…
-
### The problem
Updated the firmware of my Egardia gate-03 gateway this morning. Also installed HA core 2023.4.0 and after restart of HA the integration failed to load.
Logger: homeassistant.setup…
-
Quite all in the title : T-Beam V1.1 433MHz Doesn'twork as T-beam but as TTGOv2
Using uploader, work fine until Wifi link
As T-Beam :
The T-beam is unable to link the Wifi network and ask to get b…
fr4sw updated
1 month ago