-
I might be misunderstanding something (or doing something wrong) as I am quite new to the esp-rs community, so sorry for that in advance. I currently have some [WEMOS lolin 32 s2 mini](https://www.wem…
-
Hi,
I have nearly each day an discconnect of my CP2102 USB to UART Bridge Controller
In **journalctl** appears:
```
Dez 27 21:38:35 vcontrold kernel: cp210x ttyUSB0: usb_serial_generic_read_bu…
-
### Describe the bug
I am using a Revolution Pi Connect S, which is based on CM4-S. I have flashed a bootloader config to enable BCM-USB-MSD boot. With bootloader versions up to `pieeprom-2024-04-1…
-
hello,
Just received a few M0S dock, and started to play with sdk.
Im compiling and flashing helloworld and freertos exemple without any issue.
But how the hell am i supposed to see log messag…
-
**Describe the bug**
When sending usb packets continuously apparently some are dropped.
There are no logs from the usb subsystem that bytes were dropped.
I was testing on a nrf52840dk with the cdc_…
-
I'd like to have a log.zig logFn that I could use to emit debug logs over USB, rather than UART.
Currently Microzig has support for acting as a USB HID device. I believe emitting debug logs over US…
negz updated
2 months ago
-
Long story short: I'm getting frequent(ish) but random USB disconnects while printing with CB1 + Klipper.
Are there known issues around the USB to serial hardware or kernel driver?
Or could this b…
Dids updated
9 months ago
-
Is it possible to add support for [...](https://en.wikipedia.org/wiki/USB#Device_classes)?
- [ ] USB hub
- [ ] Human interface device (HID) [Joystick/Gamepad](https://github.com/crazii/SBEMU/issues/…
-
I have the problem that i want to set up an octopus v1.1 with klipper and I wont get a response from the board. When Inster the firmware.bin with the micro-sd and take it out again the file changed t…
-
Hi,
I think I have done everything to the letter. I have tried 4 times now from scratch but when I try to connect P3 to printer it just does nothing.
Could you please help me try to figure this …