-
```
Draw a rectangle and paste an image on it, then draw a cylinder around the
rectangle.
Now the problem is the area covered by the rectangle is not fully transparent,
It draws a semi transparent b…
-
```
Draw a rectangle and paste an image on it, then draw a cylinder around the
rectangle.
Now the problem is the area covered by the rectangle is not fully transparent,
It draws a semi transparent b…
-
```
Draw a rectangle and paste an image on it, then draw a cylinder around the
rectangle.
Now the problem is the area covered by the rectangle is not fully transparent,
It draws a semi transparent b…
-
```
Draw a rectangle and paste an image on it, then draw a cylinder around the
rectangle.
Now the problem is the area covered by the rectangle is not fully transparent,
It draws a semi transparent b…
-
```
Draw a rectangle and paste an image on it, then draw a cylinder around the
rectangle.
Now the problem is the area covered by the rectangle is not fully transparent,
It draws a semi transparent b…
-
```
Draw a rectangle and paste an image on it, then draw a cylinder around the
rectangle.
Now the problem is the area covered by the rectangle is not fully transparent,
It draws a semi transparent b…
-
```
Draw a rectangle and paste an image on it, then draw a cylinder around the
rectangle.
Now the problem is the area covered by the rectangle is not fully transparent,
It draws a semi transparent b…
-
### Description of the bug
It makes sense why there'd be retraction code at the starts and ends of a vase mode print, but when geometry is slightly more complex than a cylinder it'll generate retra…
-
Sceneform locates a cylindrical model through the anchor point. The deeper the anchor point is, the greater the negative value is. Why can't the position of the cylinder be fixed, but it wobbles?
…
-
When passing `transformation=spherical` or `transformation=cylindrical` to the coordinate system constructor, make sure that the parent's Lamé coefficients are all 1.