-
Hey, I have a problem with this library. Today I wanted to program an project with getting URL with parameters but all the time I got an errors. I use a PlatformioIO too.
There are errors:
![image…
-
luc Hi!
I am used ESP3d v 3.0 with SD card.
- MCU: ESP32
- Name: ESP32 Devkit v4
- Flash size: 4M
I connected the sd reader to the esp32 to contacts
CS D5
SCLK D17
MISO D19
MOSI D2…
-
Readings from sensor should be in real-time. This applies for ALL sensors.
-
Issue to track the SHT3x sensor implementation.
I was also thinking about extending the TempHumid plugin to support temperature-only sensors - what's your opinion on that (eg ds1820)
-
Have connected DHT11 to Rpi4.
VCC--pin 1
datapin--gpio4
Ground pin--pin 6
It works fine fine but after giving the result for few times then I get this error.
New to pigpio please do hel…
-
I'm the creator of the QuinLED-Dig-Uno boards which work excellently with either a ESP8266 or ESP32 to run Digital LEDs using WLED, for more info see: https://quinled.info/2018/09/15/quinled-dig-uno/
…
-
Hi, I discovered that when I try to combine your library with "SimpleDHT" in one sketch I need to put display.setBrightness command to setup loop. Otherwise if it is in main loop it changes the temper…
-
Jestem nowicjuszem w programowaniu procesorów, napotkałem taki problem, zainstalowałem bibliotekę MightyCore do arduino IDE na procesory Atmega, między innymi Atmega 644, który stosuję w moim projekci…
-
Code:
```
import subprocess
import time
#subprocess.call("sudo pigpiod", shell=True)
#time.sleep(0.1)
from pigpio_dht import DHT11, DHT22
while True:
gpio = 4 # BCM Numbering
…
-
Hello,
i got some of this nice P10 Outdoor Panels too.
They are 1/4 Scan Panels and i inserted the Code for the P10 Transformation provided by VolkerGoeschl (many many Thanks).
My HW-Config i…