-
Hi,
I had a rather successfull deployment of ebusd but decided to upgrade from 3.0 to 3.2 because I had a problem writing the `Hc1OPMode` parameter.
I installed the `ebusd-3.2_amd64-stretch_mqtt1.de…
-
Hi,
I had a rather successfull deployment of ebusd but decided to upgrade from 3.0 to 3.2 because I had a problem writing the `Hc1OPMode` parameter.
However, after the upgrade ebusd is unable to com…
-
Hi John.
Thanks a lot for your project, all the work done, for shating that and support it. It's a huge work.
I found your project and decided to fully manage (under Jeedom) my boiler Saunier Duva…
klona updated
5 years ago
-
I've upgraded to 3.2 and would like to decode `PrimaryCircuitFlowRate` (d.029) which is shown on my BAI but not decoded. Since ebusd-config has both `UIN` and `uin100` I'd like to test if one of the t…
andig updated
5 years ago
-
HI,
Thanks for a great piece of software.
I am just starting using it and finding my way around in it.
I was polling data via MQTT every 10 seconds and noticed at night when the heater was set to a…
-
Hi,
is there a plan to offer a binary release for Raspbian Strech on RaspberryPi/armhf? Or should the "ebusd-3.2_armhf-jessie.deb" be sufficient?
Thanks,
Michael
-
Hello,
After my SD crashed on the three-year-old RaspberryPi, I've now installed Raspbian Stretch and reinstalled EBUSD. eBUS coupler Ethernet works great. EBUSD is going great.
Munin is also in…
rchmd updated
5 years ago
-
After solving https://github.com/john30/ebusd/issues/208#issuecomment-429629552 I was able to verify that my bai:
address 00: master #1
address 03: master #11
address 05: slave #1, scanned "MF…
andig updated
5 years ago
-
Follow-up of #208. Once a custom message definition has been tested and declared via `define` it should be possible to read/write it through MQTT, too. Currently that doesn't seem possible- forced rea…
andig updated
5 years ago
-
````
pi@raspberrypi:~ $ ebusctl r FlowTempDesired
62.00
pi@raspberrypi:~ $ ebusctl r -f -c bai FlowTempDesired
62.00
pi@raspberrypi:~ $ ebusctl w -c bai FlowTempDesired 62.00
ERR: element no…
andig updated
5 years ago