-
Doing the manual leveling, it would be amazuing, having another menu entry for "previous". Unfortunately in a 5x5 levling it happens quite often (to me, and guess to others too), that you press the sc…
-
Hey,
I recently upgraded my board to the v4.2.7 for reasons of noise reduction, but I lost my M600
Just to make sure: firmware-20200903-164823-Simplest+FilChange-m600-enabled.bin is basically si…
-
**Application version**
4.6
**Platform**
Windows 10 64Bit
**Printer**
Ender3 Pro
**Reproduction steps**
Create new printer Ender3 Pro
**Screenshot(s)**
I assu…
-
Hi,
I just installed WemoSwitch plugin i configured with the ip address of wemo but when i click the icon in octoprint control panel nothing happens...
I am using macosx Catalina for octoprint.…
-
Using Marlin 2.0.6.1 with Bigtree Tech's SKR v1.4 Turbo, sensorless homing, bltouch, tmc 2209 in uart mode, disabled stealthchop in config, using bilinear bed leveling. Issue persists in today's (Sep…
-
Hello, I'm a novice so forgive me if this turns out to be a waste of your time. I couldn't get the 32 bit appimage version to run without a segmentation fault without first copying the contents of my …
-
my use ronbin e3 broad
why my extruder motor is noise ( mosquito sound ) ?
i was change other motor , it not fix