-
I have been trying to get my bltouch and filament runout sensor to work, however, I am not sure which pins to reference in the config file as I am not able to find a pinout for my printer. If anyone c…
dcv10 updated
2 years ago
-
Hi,
printer start printing without detecting filament by runout sensor.
It's possible to test status of runout sensor before printer start printing and sensor is enabled at cfg?
My printer set…
-
Foreword: I'm super new to 3D printing, Raspberry Pi's, Linux, etc. Please explain like I'm 5, I will not be upset. I know enough to be dangerous, but probably not enough to come up with this solution…
-
Can anyone tell me what to put under:
`[filament_switch_sensor my_sensor]`->`switch_pin:`
I have tried both "ar5" and "ar19", based on what I could find from the Marlin firmware for this prin…
-
After upgrade from RC5 to RC6 after each layer, all layer step by XY coordinate
-
Hi , I used your latest Marlin RCbugfix ( Latest commit a545290 6 hours ago) and uploaded it with IDE 1.6.8 , here are the results :
```
I can push the knob on "Prepare" and "Level bed" and then I tu…
-
**Printer type** - MK3S
**Printer firmware version** - 3.9.1 - 3.9.2
**MMU Upgrade** - MMU2S
**MMU upgrade firmware version** - 1.0.6
**Describe the bug**
The Filament Sensor is recognized a…
-
Hi,
I tested this version and while trying to find the best auto level routine. The g30 and g29 work reliably and as expected. When I visualize the result of g29 I get a repeatable pattern.
I print…
-
I did an 8-10 hours print last night and saw a very strange bug with the filament runout detection.
I had 8-9 runout events detected during the print although the filament was still in the runout s…
-
So i was told to get to bug fix.
My problem is I installed a BLTouch, and everything was working fine except when I printed a 10mm x 10mm x 10mm cube X and Y were ok, but Z was 15.81. So @thinkyhead …