-
### Expected Behavior
No errors logged
### Current Behavior
Seeing the following error message logged multiple times:
```
(node:26877) UnhandledPromiseRejectionWarning: Unhandled promise reje…
-
Hi All
I'm trying to add the cbus plugin through HOOBS 3.3.1 and as soon as the plugin is added, the service comes up as service stopped. If I remove the plugin the HOOBS service restarts and runs …
-
## Verify the following before opening an trouble issue
**Go over all the following points, and put an `x` in all the boxes that apply.
If you're unsure about any of these, don't hesitate to ask. …
-
Hello,
installation went good on my mac with high Sierra, used the basic config setting. Homebridge starts up just fine and the Tv platform is loaded. Then nothing more happens, I need support to fig…
-
Hi
When i copied your script with the platform and accessiories exactly as written, to my json config file in npm homebridge docker, I get an syntax error.
Is there something different after a year?…
-
I'm in a spot where I cannot get this to run properly, even though I am perfectly able to control my TV via CEC on the command line.
This was not an issue for me in my previous setup which had the …
-
### Describe The Bug:
When disarming the alarm via the panel, the plugin goes to unknown state in HK. If the alarm is disabled in HK, everything is fine and it transitions to disarmed.
### To R…
-
Does this work on a Pi Zero W? I'm running a Homebridge image on a Pi Zero W and get this when trying to start the docker:
```
WARNING: The requested image's platform (linux/arm/v7) does not matc…
-
### Prerequisite
- [X] Yes, I've read the readme completely.
### Cache
- [X] Yes, I've cleaned accessory cache and the issue still exists.
### Version
1.7.0-beta.51
### Device Infomation JSON Fi…
-
Hi there,
I'm trying to configure this plugin in my Homebridge installation on a Pi 4b. I have connected a Arduino with RFLink which is connected to the confirmed `/dev/ttyACM0` port.
When I tri…