-
The ESP is always in active mode and therefore consuming much power. The clock should offer a low-power mode that turns off wifi and force the ESP to sleep. The clock should only occasionally wake up …
-
In the end I can't save (therefore can't recall) a profile.
Initial setup:
Windows 10 19041.508
i5-6500, R9-390, 16GBram. Xbox one controller w/ Msft wireless dongle.
Using Vjoy v2.1.9 as devic…
XGC75 updated
7 months ago
-
Hi
I just wanted to share my theory on the common USB read errors with some of the AnyCubic models.
I had issues where it would not read Lexar USB sticks at all and from what I gathered AnyCubi…
-
[Support](https://www.phoronix.com/scan.php?page=news_item&px=Linux-ACPI-Platform-Profile) for native power profiles (low power/regular/performance, etc) is in kernel 5.12, facilitating an easy interf…
-
The [power boot module](https://learn.adafruit.com/adafruit-powerboost-1000-basic/pinouts) has a 'LBO' Low Battery Output pin. Use it to push a low bat signal which the gateway will turn into a low …
-
I notice a little bug using this vtx.
If I set the low and high power differente value, for example low 25 and high 200 when I arm the model, after few seconds the video turn off (not vtx, I can see …
-
# Arduino UNO R3 and Arduino UNO R4 WiFi default 5 volts pin issue
Here we test just the sensor to verify that the lectures of the temperature were right, the problem surges when we measure with a …
-
Cc: @adamcogan @jimmidier @duanxinhuan
To myself,
### Pain
Feedback from @adamcogan
> In that current Sprint there is something else to think about than just bugs. We should have a PBI that …
-
If using UART/Serial port it works fine until first call to idle() after that serial is not working (it's sending just garbage). It would seem like UART settings get lost duing low power state and i…
-
Hi,
when I use the EDSY retrofit report under ANALYSIS I get a handy list of all materials needed to upgrade from my current build to my target build.
If possible I'd like to be able to import thi…