-
Hi guys,
I am using an ESP12E to read a temperature sensor every minute and post the data to a webserver. The module reads the data from the sensor, post it and go into deepsleep for 60 seconds. My c…
-
**Rationale:**
The IDF has a full HTTP stack included in `esp_http_client.h` and it would be nice to expose this instead of the old http.c/httpclient.c version. Currently there's no `http` module a…
-
Refering to Issue #137. It is there stated that setting the mode of the ADC is impossible from inside setup() or loop(). Only possible from a #define statment before compiling. This is only almost tru…
-
Hi,
I've been wondering about something here. Go has support to build for the ARM architecture that some micro-controllers has. Such as Cortex M4 which is ARMv7 (ARMv7E-M).
Why isn't the Go code…
-
Hi,
is there a way to shorten the measurement values to only one digit after the comma instead of actual two?
-
i bought a nodemcu lua
and suddenly it stopped working
-
### Background
Hello Paul, I am currently the lead active maintainer / committer on the [NodeMCU firmware](/nodemcu/nodemcu-firmware) project. (I've given a poke about this if you want to track the…
-
8 this is probably my messages from 9600bps...
### Test code
Works fine when built with LUA_FLASH_STORE not defined, calling init.lua properly.
When built with it defined I see the above messages…
-
Hi,
i've used your code before and it worked.
I used it with an Wemos NodeMCU Mini D1 and a BME280 1.8-5V Breakoutboard (purple board with only 4 wire outputs - VCC,GND,SDA,SCL).
Today i've bou…
-
IRController used to work fine for me, but after updating to recent versions (including the current latest), I've run into a consistent issue.
When installing and booting IRController, it installs …