-
I think we need to think about a proper treatment of boundary pores for both linear transport and percolation. And whether we need them and whether taking them out causes more problems than keeping th…
-
I have imported my pore network model to OpenPNM.
I plan to calculate relative permeabilities.
https://github.com/PMEAL/OpenPNM-Examples/blob/master/Simulations/relative_diffusivity.md was helpf…
-
I am creating my SFCW signal as follow in MATLAB:
```
c = 3e8;
delf = 80;% MHz
f = 1e6*(800:delf:1600);
dr = c/(2*range(f))
R = dr*5 % range
t_delay = 2*R/c % delay
PRI = 1.0*t_delay;
…
-
Dear PK-Simmers,
For an oral small molecule compound with very high solubility at pH < 2-3 and very poor solubility at pH >3, I’m building a PBPK model. Naturally, the ideal workflow would have bee…
-
Tagging @cpgr @hsheldon
## Rationale
The full upwinding used in PorousFlow is too diffusive for problems involving the tracking of fronts, so a new type of upwinding needs to be implemented t…
-
We have `FickianDiffusion.calc_eff_diffusivity` whereas `StokesFlow.calc_effective_permeability`.
-
I am studying the circuit of a ZVS oscillator and need to simulate an inductor of 4uH, but derived in the middle, similarly to what is in the diagram described below.
```
$ 1 0.000005 2.803162…
-
Hi,
I'm working on a compound that is diprotic base and when I use both the pka's (6.51 & 2.94) as a base the concentrations (Cmax) is very low almost 5 times lower than observed concentrations fro…
-
Hey Everyone,
We are trying to run Deepchem membrane_permeability example in distributed training mode using TensorFlow Estimator. I followed the example as given on the Deepchem repo (https://deep…
-
Digoxin:
Kd of ATP1A2-katz (2010) should be 25.6 nmol/L (and not µmol/L)
Lipophilicity should be 1.623 (instead of 1.62)
Specific organ permeability should be 1.01150E-5 dm/min (and not cm/min)