-
tried to set spindle speed to 50%. the spindle rpm runs full speed (measured ttl pin still at 5v, the same when it was set to 100%)
and then the speed become slower after i pull down spindle setti…
-
### Problem:
External I2C connections (into cable) are not consistent with others using the same cable ([Project Haar](https://github.com/NorthernWidget-Skunkworks/Project-Haar))
### Potential Sol…
-
The WLED UI does helpfully warn you if you try to use "input only" pins on the ESP32 for the strip outputs, but this info does not show up anywhere in WLED documentation - though I did find this forum…
-
- Arduino board: Arduino Due
- Arduino IDE version (found in Arduino -> About Arduino menu): 1.8.13
- List the steps to reproduce the problem below (if possible attach a sketch or
copy the …
-
### Discussed in https://github.com/fra589/grbl-Mega-5X/discussions/280
Originally posted by **mcinquino** July 29, 2022
Hello,
I see that in the pinout diagram there are 4 digital inputs o…
-
**Is your feature request related to a problem? Please describe.**
no
**Describe the solution you'd like**
alternative aliexpress CH376 usb module support
**Describe alternatives you've consid…
-
Hi, what a great repo, thanks for setting this up. I'm considering making a new TAM base unit so your pinout for the Connector is very helpful. A few things I don't understand
1) What is RTRN?
2) …
-
IMHO there should be a feature (i.e. built into the overlay 'data' itself, rather than just included in the 'markdown' part) for boards that "uses_i2c" to include the i2c address(es) the board uses. W…
lurch updated
3 years ago
-
Hi there Edwin,
thanks for this awesome project!
I'm currently active with some projects involving a Xbox Adaptive Controller.
I think it's possible to connect your (or Marcs) Split controlle…
-
```
Similar to the External LED enhancement request, a piezo buzzer connected to
APM board will sound:
Constant beep until Accel/Telem/Gyro has initialized
Momentary long beeps until GPS location is…