-
Hi. Thank you all for this nice 1541 emulator for C64 using RPi :) works great.
BUT!:
I like to suggest a more robust way to do this:
source code to make a ARM binary that is executed using comma…
-
PTT 24 26
I tried that and only 24 goes high on ptt. would be fun to hookup a red LED to 26.
-
Hi,
I am trying to combine an OLED display with a RFID reader. The OLED should give status informations about the user. I used the procedure described here (https://www.raspberrypi-spy.co.uk/2018/04/…
-
Hi,
i bought version 2.1 and i am trying to run it on a raspberry 4 later in combination with the led ring (both connected to the RPi).
I2C is set to 100kHz in the config.txt
Now it occurs aft…
-
I have an issue with this plugin. The filament sensor is recognize (/plugin/filamentreload/status OK), the print doesn't start when filament is out but during a print if I take off the filament nothin…
-
```
*** ./spimain.c.old 2013-06-26 09:40:51.000000000 +0400
--- ./spimain.c 2015-07-14 20:49:14.284691132 +0300
*************** uint8_t mode = BCM2835_SPI_MODE0;
*** 103,108 ****
--- 103,109 ----
ui…
-
Make a new settings page to configure GPIOs on the RPi for the following functions:
1. HIGH/LOW on WebMCP running/not running
2. HIGH/LOW on WebControl running/not running
3. digitalRead to initi…
-
The firmware outputs via SerialUSB but I cannot see any code to output to the pi via GPIO.
-
´´´
sudo apt-get update
sudo apt-get install python-pip
sudo apt-get install python-scipy
´´´
https://forums.raspberrypi.com/viewtopic.php?t=88020
sudo apt-get install python3-dev python3-…
-
Attempting to create a Button object with a bounce_time of less than 0.001 results in "ValueError: Bouncetime must be greater than 0"
If the lower limit for bounce_time is 0,001 should this not be …