-
I have a problem, that may be related to #3114, but this time on a Raspberry Pi Zero.
Basic setup:
* raspberry pi 4 as AP (on board wifi - member of a bridge)
* raspberry zero w in client mode (o…
-
During upstream review of the Raspberry Pi 4 devicetree some questions has been raised by Marc Zyngier [1].
1. How is the maintenance interrupt of the gic400 defined?
2. How is the interrupt-affin…
-
Hello
I'm using ``cloudflared proxy-dns --port 5053 --max-upstream-conns 0``. When my ISP connection goes down, cloudflared prompty logs the following:
``cloudflared[3095]: 2021-09-03T15:21:19Z …
-
This is the repo I have been looking for - and you have done it extremely well!
I am working on something very similar: I want to use my RPi 3B in an "off-grid" application. The system is powered …
-
Would it be possible to modiy it for Tensorflow Lite?
This should be much faster on a RPi
Xento updated
2 months ago
-
Hi! I have a Pi4 with a PiJuice module and a 12000mAh LiPo battery. I also have a solar panel connected. The entire setup is placed in a rather remote region. Now I have the Pi set up such that it sho…
-
Wenn ich das richtig gehört/verstanden habe benötigt die 2.17 Firmware noch einen speziellen low-latency tty-Treiber damit crRFD/multimacd funktioniert? Ist das richtig? Wenn ja - ist dieser Treiber s…
-
Good Day,
I am trying to use an alternative battery and have figured out most of the profile settings. however I do not know what values to use for OCV10, OCV50, OCV90 and R10, R50, R90
1. What …
-
Not sure how many LSL users out there on RaspberryPi, but I had a project recently and noticed a couple problems:
The distro that pip fetches on a pi does not come with a 32-bit build of liblsl. I …
-
Hello,
I'm working on a project with RGBW leds. I would love to used Fastled, but its seems quite difficult to adapt the librairie for RGBW leds, as every functions are for RGB.
Is there a way to use…