-
When njsPC is connected to the controller through a network connection commands to turn on/off functions fail after the program has been running a while - typically an hour or more. However, the Dash…
-
**Describe the bug:**
Unable to build or load corpses to Replimat Cadaver Processor
**Expected behavior:**
**Steps to reproduce:**
1. Play Game with mode Replimat, Humanoid Ali…
-
Hi everybody,
I get random disconnects from devices that had previously been paired and working just fine with `zigbee2mqtt`. How can I avoid these in the future? I use a single `Texas Instruments …
-
**Home Assistant release with the issue:**
hassos: "2.11"
homeassistant: 0.92.2
machine: raspberrypi3
supervisor: "162"
**Operating environment (Hass.io/Docker/Windows/etc.):**
Hass.io
**Co…
-
Hi,
after updating the addon to version 1.21.0-1, I noticed that to display the cc2530 key I have to stop the addon, remove the key from the USB port, wait a few seconds, reconnect the USB key, start…
-
I have completed the zh_ch.lang file. Do you need it?
-
It would be good to be able to set the current temperature as well as the target temperature. The temp sensor in the unit, especially for the large convention ducted units, is not an accurate represe…
-
**ELKO Smart RS16 Super TR RF PH - Thermostat**
**Technical specifications:**
_Voltage: 230 V/50-60 Hz.
Max load: 2300W
Electronic short circuit fuse
Temperature sensor: Airsensor, floorsensor…
-
There is a board on ESP32. Compiled the firmware based on Marlin 2.0.9 and Esp3dlib. But there is no connection between the WEB interface and the firmware. A similar GR BL firmware works on this boar…
-
- [x] **I have read the [README](https://github.com/iMicknl/ha-tahoma/blob/master/README.md), including the [advanced](https://github.com/iMicknl/ha-tahoma/blob/master/README.md#advanced) section rega…