-
```
What steps will reproduce the problem?
1. Call tone(13,31). You will see a very fast blinking on the LED.
2. Call tone(13,30). You will see a seemingly continuously lit LED (it actually
is a very…
-
Could you please document the pinout of the motor connector for EBB36 / 42. The pinout diagrams and manual do not provide this information.
-
**Describe the problem you have/What new integration you would like**
I'm just wondering is there any possibilities to add easydriver stepper driver support to the supported devices list? There i…
-
Where can I find the i2c commands, address, etc?
-
## Discussed in https://github.com/arkypita/LaserGRBL/discussions/2079
Originally posted by **MrGadjit** June 7, 2023
Hi
Can anybody help me. I am using Laser Grbl with an Arduion based Con…
-
Tony was engraving a sizeable piece of acrylic (about A2), and fairly early on drifted off course quite dramatically and threw up the following errors:
![image](https://user-images.githubuserconten…
-
### Description
I have a printer that uses 4 lead screws to move a reasonably large bed. The lead screws are to be used to level the bed mechanically rather than through the firmware based Z ax…
-
-
```
Hi,
thanks for pyduino. I'm using it successfully on Linux with my Arduino
(Duemillanuove) and extended it to support stepper motors (by adding some extra
sysex commands to the firmata protocol)…
-
I am trying to correct an issue I have with running the z-axis stepper motors through one port. This motherboard has a second z-axis connection that I am hoping will use its own driver. I know that …