-
If you set a current of 900 mA or higher, then the driver overheats already during the calibration process.
Driver temperature reaches 120 degrees
-
Help me. Log files:
Configuring upload protocol...
AVAILABLE: blackmagic, dfu, jlink, serial, stlink
CURRENT: upload_protocol = stlink
Uploading .pio\build\mmu-skrmini\firmware.elf
xPack OpenOCD,…
-
I have modified the firmware for the TMC2208 UART and LPC1768 software serial lib sections, Now it's not necessary to use interrupt IO for RX, Does anyone want to test it? I can send you the complete …
-
Hello everyone
I want to share my experience with my sbase board and clarify some doubts I have.
At the moment I have configured and working.
USB to PC, TFT35, LCD12864 Reprap Discount Full Graph…
-
While printing with TMC2208 i hear a crack while it's printing the first layer and suddenly it's printing twice the size, .. again turn of the printer restart everything, and suddenly everything goes …
Ofloo updated
4 years ago
-
Hello, I'm just trying to save config with "stock firmware", but settings are not storing in SDCard not EEPROM.
How can I save config?
Thanks in advance.
-
### Description
Incorrect PIN assignment in pins_RAMPS.h (both bugfix 1.1.x and bugfix 2.0.x branches)
When using a MKS_MINI_12864 display on a BOARD_MKS_GEN_L board that the assignment pin numb…
-
I followed this german guide (http://3d-druckerei.blogspot.de/2018/03/blog-post.html) to integrate my TMC drivers into Marlin.
And it looks like only the last driver "E0" is activated.
```
> Send: …
-
I am having a hard time getting my TMC2208 steppers to work on my RAMPS clone, only one of four steppers is able to communicate.
I am testing this on a MKS Gen L 1.0 with the latest bugfix-2.0.x comm…
-
### Description
My new setup is a Bigtree SKR v1.3 with TMC2208 in UART mode from watterott.
UART Connection is ok, stepper drivers are working.
From Octoprint Terminal i can use gcode co…