-
When I tried to add this blueprint I received this message in my Home Assistant instance:
```
Invalid blueprint: extra keys not allowed @ data['blueprint']['input']['actions_section']['collapsed']…
-
How do we define setpoint? I personally like [Wikipedia's](https://en.wikipedia.org/wiki/Setpoint_(control_system)) definition:
> The desired or target value for an essential variable, or process val…
-
This is not really an issue, but perhaps you can add units, as with the other measured values.
The units m³/h and Hz are missing for volume flow and fan speed.
![image](https://github.com/pail23…
-
When I try to compile and install the module for 5.10.11-v7+ Kernel on my RPi2, I get a crash stacktrace:
```
root@cybrasp-ke:~/ttyebus# make install
cp ttyebus.ko /lib/modules/5.10.11-v7+/kernel…
-
### The problem
I use typical setup for pmsx003, but there is an issue with reading the values.
It seems that just after it starts the cycle i gets pretty low value and than it stabilize it self i…
-
I am using your controller and connector script permanently, thanks a lot for the great work.
I would like to suggest an enhancement to show a few more info's unless not set.
I would like to sh…
-
Issue overview
--------------
After getting the defect file from https://github.com/NREL/EnergyPlus/issues/10665 which does run in 24.1, I transitionned it to 24.2 (no real change in the idf forma…
-
FIrst started occurring after e86899ed31c4df5aceed12f159ed8cb0f5604592. Easiest observed in Duke 3D. Start a new game, observe the sky dome cap is grey-ish. Go down the ventilation shaft and then obse…
-
An existing ventilation mode is not checked when the roller blind should be shaded.
- Shading to 45%
- although contact sensor open (ventilation 89%)
- Either move to ventilation only or do noth…
-
Dear Sanaa Hamel, thank you for this great Project. I am working at the moment on a ventilation System. This System will ensure an proper ventilation in my 3d printer enclosure. The System will have 2…