-
Hi,
I like this project, thanks a lot.
I did all you recommand but when when I include MQTT client, the only command founded is "Spa/Node" with the status ON.
Can you explain me why ? My jeedom (MQ…
-
Hello phdlee,
I discovered your firmware here on github almost by chance. since I have a k5 dedicated to testing and a si4732 in the drawer, I'll try to put it in place of the original chip! I just h…
-
When I set up RGB OFF it stops with "-> Enter state Measure".
My setup is Cube Cell, HX711, DHT22, no One-wire
I have tried to set "#define THERMOMETER_COUNT 5" to "0", but then the compilation fai…
-
Hi there, running into an issue and do not know where to really begin to debug it.
In file included from sketch\Settings.h:53:0,
from C:\Users\nogardvfx\Downloads\printer-monitor-…
-
Allow precompiled headers to be used when compiling C++, to make the build faster.
-
Hi,
I'm using the latest firmware (tag 1.1.7 i guess) on the open source hardware.
the sketch compiles and run fine, the application detects when sensor is up and launch a calibration when dark.
…
-
Not really an issue or a feature request, I just wanted to put out there that I've got Faikin working on my head unit!
**Daikin hardware**
FTX12NMVJUA
Direct connection on S403 using:
```
Fa…
-
I have this wheel and would like to use it on my Playstation 2 and 3 (with ps2 emulation)
There is no force feedback so no motor control needed. Just the spring, axis and buttons.
-
### Description
CR-Touch doesnt Auto home properly using the marlin firmware.
I already tried adjusting some settings in the firmware.
defining USE_PROBE_FOR_Z_HOMING and BLTouchv
### S…
Loifu updated
3 months ago
-
I'm hoping to work out whether or not this can be used with my Flexispot EQ5 model which uses the CB38M2D(PB)-2 control unit with Sanodesk LCD controller.
The control unit doesn't have a spare RJ45 …