-
```
What steps will reproduce the problem?
1. Receive remote analog data.
in
void XBee::readPacket() {
...
if (_pos > 0 && b == START_BYTE && ATAP == 2) {
// new packet start before prev…
-
```
What steps will reproduce the problem?
1.All attempts to view mavlink data with MinimOSD as master Telem device after
fw r726 update fails to show live readings.
2.System works fine with old non …
-
```
What steps will reproduce the problem?
1.All attempts to view mavlink data with MinimOSD as master Telem device after
fw r726 update fails to show live readings.
2.System works fine with old non …
-
```
What steps will reproduce the problem?
1. Set radio to give you first switch at PWM pulsewidth > 1620 && pulsewidth
-
```
What steps will reproduce the problem?
1. Tested with elevon mixing on, but may exist in other modes
2. When you switch into Stabilize mode, throttle goes to 50% and cannot be
manually overridden…
-
```
Instead of having the battery hooked up to a meter that buzzes why not have a
voltage divider attached to one of the analouge read pins?
that way the xbee could radio the battery level constantly…
-
```
What steps will reproduce the problem?
1.All attempts to view mavlink data with MinimOSD as master Telem device after
fw r726 update fails to show live readings.
2.System works fine with old non …
-
```
What steps will reproduce the problem?
1. Tested with elevon mixing on, but may exist in other modes
2. When you switch into Stabilize mode, throttle goes to 50% and cannot be
manually overridden…
-
```
What steps will reproduce the problem?
1. Connect one of the new XBee PRO S2B radios
2. Run any of the test programs
What is the expected output? What do you see instead?
I expected: XBee radio i…
-
```
What steps will reproduce the problem?
1.All attempts to view mavlink data with MinimOSD as master Telem device after
fw r726 update fails to show live readings.
2.System works fine with old non …