-
I don't know if this is a problem of the compiler or of Tasmota itself.
ESP32 Generic, leave everything as in the default settings. In the details
#define USE_I2C
#define USE_ENS16x
#defi…
-
A slave device gets no data, even it's a copy from another slave device and the master is getting data.
Master:
```
Internals:
.FhemMetaInternals 1
ADDRESS feinstaubsensor.fritz.box
…
-
![Datenlogger](https://github.com/ZieBar/M.A.-Thesis/assets/133433673/bf3ab6aa-e16b-405e-a651-9d1d8c17e41f)
![Kommunikation](https://github.com/ZieBar/M.A.-Thesis/assets/133433673/2a19a4f3-1f4c-451…
-
Currently, we only support initializing the polling interval of an I2C component. However, some I2C components have _extra_ parameters which may influence sensor readings.
Examples:
* Light sensor…
-
**Proposed Solution**
We are given an LLVM IR file as input, along with a Newton specification. The goal is to parse the IR file and for every operation, which includes Newton-defined signals, to per…
-
During a build I get:
```
CMake Error at /workdir/ncs/nrf/zephyr/cmake/extensions.cmake:372 (add_library):
Cannot find source file:
/workdir/ncs/nrf/ext/BSEC_1.4.8.0_Generic_Release/exampl…
-
I tried this library with my BME680 and I am 100% sure it gives wrong results in warmer rooms. The formula used to calculate `tvoc` is definitely not properly accounting for temperature. In a room wit…
-
After updating MiniMQTT from version 7.3.2 to 7.4.1, I have a problem with the loop() function, which, upon closer investigation, throws an MMQTTException (this issue occurs every second call). The ex…
-
I cut off pins 2 to 10 so I could fit a bme680 on my Pi Zero. After lots of investigation it turns out VCC for the 2.13 Inch E-Ink Display pHAT is not on pin1 of the 40 pin connector, but on pin 2.
…
-
Hey I see you are one of the few that seem to be using OPi Z2 to run octoprint. Have you had any luck finding and running any GPio plugins? I want to read a BME680 and control a fan based on it's read…