-
Unsure why it shows up like this but it has happened a few times now. Even after u…
-
Hi,
I am looking for a way to get custom firmware on an XM510 wired network camera with JX-H42 sensor. The description in this repository is not 100% clear on what camera types are supported with t…
-
Running wz on two v2 and 3 v3's. They all got new SD cards, got flashed and were all working perfectly.
Until, out of nowhere, one of them would not work in Frigate anymore using go2rtc. Started deb…
-
Installed Version 0.2.6.1 on Wysecam V2. New firmware booted and can access the web interface but cannot access RTSP on port 8554 or 554.
When I enable RTSP H264 Server under Camera Controls, it i…
-
Recently picked up fiddling with my Dafang camera again.
Found that the WebGUI for the SD-card handling is extremely slow.
Loading the SD-card Motion webpage took about 30 seconds to load for 500 fi…
-
Thank you for the awesome solution - I really appreciate all the work that has been tackled.
I'd like to understand the ability or manner in which you configure a camera to use a static IP address …
-
Hi,
I have just received two xiaofang but it's impossible for me to run the snx-autorun.sh
When i put the sd in the xiaofang i can hear a "bip-bip" but the http://IP-CAMERA/cgi-bin/status and ht…
-
## Description
If your issue was resolved, please consider contributing back to the project by creating a pull request to improve the code or documentation in order to avoid that this issue arises ag…
-
Hi all,
I had wz_mini_hacks running okay a few days ago, then my camera stopped responding after making some config changes in the web ui. I have since not been able to flash the firmware back to …
-
i have the xiaofang 1s with arm chip
fang-hack is successfully installed and rtsp stream works (checked with vlc)
now what do i do?
i just cant figure out how to install mqtt, im very new to al…