-
**Describe the problem you have/What new integration you would like**
Please consider looking at using Sonoff ZBBridge as a WiFi-connected networked Zigbee serial adapter for projects like ZH…
-
### Board
ESP32-C6
### Device Description
ESP32-C6-WROOM-1-N8 Board
### Hardware Configuration
GPIO 4,5 are connected to GSM Module TX RX respectively
### Version
latest master (checkout manual…
-
How do you set this file? does it have to output latex? xml? can it accept warnings or other stuff? also where do things have to be in relation to each other in term of directory?
-
Hi:
Have you ever considered de possibility to including support for serial LoRa devices such as E32-433T20DT. Y do understand there is already a crate for that. But to be honest i does not play ni…
-
Trying to set the configuration on ESP8266 (Wemos D1 Mini) with E220-900T22D.
E220 in config mode.
Reading the config with Success, but setting config results always in soft reset.
EByte LoRa E220 …
-
Using ESP32 Devkit v1, Ebyte E220-900T30D for Sender and Receiver. Have rung out wiring with DMM continuity tests.
Only have an AUX_PIN interrupt when receiver serial monitor is opened or ESP32 is r…
-
Hi,
Have been following this github and gitter about alternative firmware for NRF52832, excellent info @fanoush !
Now I would like to flash my Nrf52832 (actually a E73.....) with Micropython usi…
-
Pre advising of likely upcoming device support.
Elelabs Zigbee have 2 old radio modules with unknown firmware that is based on the EM357:
Elelabs Zigbee Raspberry Pi Shield EZBPIS and Elelabs Zigbee…
-
Hello!
I am using J-Link EDU Mini to flash firmware into b-parasite 2.0. When I try to connect using J-Link Commander I get such an error:
```
SEGGER J-Link Commander V7.80c (Compiled Sep 27 2022…
-
For an initial description and symptoms see kieler/elkjs#74.
My first guess would be that some properties of the graph provided there yield invalid positions after layout with force. However, solel…