-
Hello, I have a BTT SKR2 board and Fysetc TMC2209 v3.0 drivers. The board has Marlin firmware loaded (I've tested on several versions, and same error) to work with the rev b model board and F429 ch…
-
Can you upload newer firmware , then the one in clone board?
(prusa3d_fw_MK3S_3_9_3_3556.hex)
thx
-
Hello I have a problem again. The board arrived and I got it working. I did calibrate the Z endstop and the probe everything was working fine. I did change the fan connection to PB2-24v 2x controller …
-
Hello,
I'm using an ebb36 toolhead connected to the can0 interface.
It's not possible to complete a print using the catalyst can0 interface at 1M bit rate.
After 10 minutes of printing klippe…
-
Good Day,
I have a problem with connecting this LCD to my MKS Gen L V2.1 on Marlin 2.0.9.1.
LCD lights up, but no visible text appears.
EXP1 wire inverted (if it wasn't nothing would have appeare…
-
I am running the SD-WIFI-PRO on a Prusa MK3S+. My SD-WIFI-PRO is in AP mode and is connected to my home wifi.
I found that reloading the SD-WIFI-PRO's internal webpage would interrupt my print. (Fu…
-
I am using Klipper firmware.
Only the motor inserted in z works. I tried different ports, the motors do not spin in any port
![20220204_190339](https://user-images.githubusercontent.com/22075591/152…
-
This issue will automatically convert a Grbl_Esp32 "machine.h" file to FluidNC YAML format.
Change YOUR NAME in the title to some string that identifies your machine configuration.
Attach your M…
-
This issue will automatically convert a Grbl_Esp32 "machine.h" file to FluidNC YAML format.
Change YOUR NAME in the title to some string that identifies your machine configuration.
Attach your M…
-
Hi,
I'm the owner of a MKS Robin v2.2, which runs Marlin 2.0.x without hassle since a while. However, i have some serious issues with the bootloader. In fact it tends to display or not a "SDERRng" me…