-
- [ ] Create generic function to extract all impedance data
- [ ] Figure out what else is needed to get rid of all the other Impedance scripts
- [ ] Create a simple script/function? for user to p…
-
Hello,
I'm just asking whether it would be possible to add to the NanoVNA menu the "absolute impedance" /Z/ as well, rather than only resistance (real and imag) separately.
Real and Imag part is im…
-
Vypadá to že I2C signály displeje mají nízkou impedanci.
![image](https://user-images.githubusercontent.com/1194177/202570250-92e41da6-aaf7-4300-b54f-6e5ae41404c1.png)
Bylo by tak zřejmě vhodné …
-
This graph seems to indicate there is likely a high impedance mismatch. See the figure which was taken with between two and three meters of coax between TX and RX.
![brown and new cable no cal](htt…
-
Dear RonAaron61,
I hope this message finds you well.
My name is Peng Piao, and I have been deeply inspired by your project on the ESP32 S2 microcontroller-based Electrical Impedance Tomography (…
-
Exception: Impedance is too high (limit >3000ohm) is rised if Mi Scale 2 report only weight, measure in socks ;)
Steps to reproduce the behavior:
1. Run bt-mqtt-gateway
2. Stand on Mi Scale 2 in …
-
When trying to assign a pin to HiZ I get a hard low drive instead. Reproducer below. I dub this bug "resisting high impedance" :)
ent.vhdl:
```
library ieee;
use ieee.std_logic_1164.all;
enti…
-
Hi,
Is there any script to convert an EDI file in format of Spectra to Impedance?
Thanks,
Sasha
-
How it would work:
1. Ignore any impedance in lines/transformers
2. Turn cycles in the network graph into single buses by merging all buses in each cycle.
3. Calculate the flow of active and reacti…
-
orry sir, i may ask why at the start of the frequency the impedance value drops?
please what is the solution sir?