-
Steps:
1) Go to "Settings: Application"
2) Set "Lathe mode" to "Radius" or "Diameter" then save settings.
3) Close ioSender and open it again.
4) Go to "Settings: GRBL"
5) Open "Limits"
6) Click…
-
I am learning to use the new G71.X command in Linuxcnc 2.9 on my CNC Lathe and found what may be a bug, or more likely pilot error.....not sure. The simple part profile code shown below should reprod…
-
I believe axis should check jog_order before returning a value in the get_max_jog_speed function. Or any other fix that prevents the function from erroring when an axis isn't defined
## Here are th…
-
Hello Terjeio,
Congratulation for your work, I'm a big fan!
Have you planned to use the 3 uarts on the F401, because on my modular router I have a
- hyuang VFD, UART
- or Plasma THC adc (i2c…
-
I have searched a lot over the internet but could not figure out the G-code syntax for touch off and saving that tool height in non-volatile memory just like work offsets. What are all queries related…
-
INFO:qdarkstyle:QSS file successfully loaded.
INFO:qdarkstyle:Found version patches to be applied.
INFO:qdarkstyle:Found application patches to be applied.
INFO:VideoTrans::::开始处理第1个视频(共1个):【X:/木工非…
-
Good Morning all,
Would it be possible for someone to add a page to the Wiki that explains the correct way to wire NC limit switches. maybe with a schematic drawn up. I have been confused about this …
tklus updated
11 months ago
-
When using the 2nd spindle on a multiple spindle lathe setup, the g95 feed per revolution does not work. It will only feed in g95 mode when the main (spindle.0) is running
## Here are the steps I f…
-
After #51669 is merged, I plan to write documentation for it, and try to update/rewrite a bunch of our existing module-related documentation. While there are a lot of good examples in this issue track…
-
When I tried to make a thread using ioSender, I got Error:41 on G76 command.
To make it work I have to do couple things:
- in function spindle_on() comment out spindleDataReset() - with this call …