-
Hi!
I get error on install
root@mkspi:~/moonraker-timelapse# make install
YOU DONT NEED TO RUN INSTALLER AS ROOT!
You will be prompted for sudo password if needed!
Exiting...
…
-
After I have installed the firmware "For Ender3 TMC2209 + 3Dtouch" via an SD card and want to approach the reference via "AutoHome", the printer moves to the stop of the X axis. The stop for reference…
-
I am trying to compile marlin 2.1.2 for my new nano robin v3.1
Getting 2 errors:
1) boards.h = "operator '==' has no right operand",
#define _MB_1(B) (defined(BOARD_##B) && MOTHERBOARD==BOAR…
-
### Is your feature request related to a problem?
MKS update the plugin to support MKS Tinybee board but this pluging doesn't work with Cura 5.x
Is it possible your pluging support this board, pleas…
-
I'm a bit puzzled...
on the doc https://github.com/bigtreetech/BIGTREETECH-S42B-V1.0/blob/master/42%20Stepper%20Motor%20Closed%20Loop%20Driver%20Control%20Board%20Manual.pdf, there is written that 2…
-
hi i made a 3d printer (old ender 3) i replaced the motors the drivers the MB the belts the hotend.
to
moter: 42BYGHW811 (from a old k8200)
driver: mks servo42c (X,Y and Z)
mb: ramps 1.4
belts:…
-
I tried to install a Robin Nano E3P card on an Ender 3 v1 with a TS35 screen, everything goes relatively well until the addition of a 3D Touch (ordered on aliexpress in the Makerbase shop), the printe…
-
Hello, my TTS 55 10w burner is also equipped with an MKS LTS v1 card, and I would like to be able to control my air assit with the SCL output as in this tutorial "https://forum.lightburnsoftware.com/t…
-
I have installed the last version 1.0.8, since than the 3d model doesn't appear anymore, instead I see a picture with "G."
There are something to do to view again the 3d model printing?
-
In the 'no graphics' issue I described some problems I have encountered to set up a new Makerbase-mks-Robin-Nano v2.0 board with TMC 2209 drivers, in accordance with my old Hictop DP17 printer configu…