-
## Bug Report
### Description
Since the last two updates this week when I open the app I randomly get a tilt screw adjust pop up.
### Steps to Reproduce
1. Open app
2. Exit app
3. Wait a co…
-
I wasn't getting snapshots in my notifications and was trying to track down why. It turns out in the logs, there was a 503 error when trying to access the snapshot url and it was not using what I put …
-
## Bug Report
### Description
I have reverse proxied my Fluidd and Moonraker into the network. When I enter the webpage, I can see the camera, but the camera does not display from within the app.
…
-
## Bug Report
### Description
A clear and concise description of the bug.
### Steps to Reproduce
1. Go to 'Main screen'
2. See the error.
### Expected Behavior
I got an app update today t…
-
## Bug Report
### Description
I don't have a webcam and there is no webcam configured in the printer settings.
Yet, since I updated Mobileraker (I know, my own fault) there is a webcam panel on…
-
### Requested feature:
it would be very usefull to have this feature
and even better, to execute custom g-code when spool is selected, for example to pre-heat extruder and load filament, and maybe p…
-
## Bug Report
### Description
If you have a frame thermal sensor configured its Set as "z thermal adjust", and Shows up as a normal sensor in the thermals Tab on the Webserver. However not on the mob…
-
## Feature Request
### Problem Description
I use a couple of Wyze cameras to monitor my printer and enclosure. They are streamed to Mainsail via WyzeBridge which uses WebRTC/MediaMTX. Support for …
-
## Feature Request
Spoolman spool info card uses poor formatting above 1kg. instead of a gram unit display (451/1000grams), it uses kilograms when loaded with spools above 1kg. (3kg / 5kg)
### P…
-
Hello, I am facing similar Moonraker issues after updating Klipper as described in the last couple of reports. But I am not being able to solve them by following #83
The errors I get are the follo…