-
### The problem
After the initial connect Opentherm Gateway disconnect and doesn‘t do anything any more. After Restarting the integration it works once an then stops again.
Ot-Monitor doesn‘t sh…
-
### Describe the bug.
After upgrade HA version 2022.11.1 or 2011.11.2 the Plugwise integration stopt working, and this error: Failed to set up
Log message:
Logger: homeassistant.config_entries
…
-
### PROBLEM DESCRIPTION
_A clear and concise description of what the problem is._
I compiled tasmota 8.3.1 code and configured according instructions https://tasmota.github.io/docs/OpenTherm/ fo…
-
Hi
I have the Ebyte E07 dev board with uart. The processor is an stm8, does anyone know how to port this code for an STM8?
-
Hi everyone , I have installed 9 of these Eurotronic Spirit TRV on my radiators - controlled by home assistant. All looks good from the automation stand point, with the TRV's changing their target t…
-
### Describe the bug.
See https://github.com/home-assistant/core/issues/72305
### Expected behavior
Showing an OpenTherm device.
### What version of Home Assistant Core has the issue?
2022.4.0
#…
-
## What happened: Device is not supported
## What did you expect to happen: Expected to follow the procedure to add the device and review debug level logs - logs are empty. wireshark output included …
-
### Describe the bug.
The `opentherm_heating` state should only be enabled when heating (Anna radiator icon), but it also enabled when using just hot tap water (Anna tap icon). This might be a proble…
-
Memory goes sky high and app stops responding. I've sent a diagnostic report earlier.
Firmware upgrade done around 10am this morning.
![image](https://user-images.githubusercontent.com/18558267/1564…
-
### Describe the solution you are looking for
Buying the adam I was under the impression that I would be able to control my heater directly. Currently I can only control it through my Lisa though. I'…