-
When flashing 3.1.1 the lua takes about 10 minutes to load. This can be helped a tiny bit by increasing the baud rate. Once loaded the options are not working at all. Reverting back to 3.0.1 fixes the…
-
I am running V2.2.1 (had same problem with previous versions as well) on a Jumper T16 running EdgeTX 2.7.0 and a R9M TX module. The LUA widget is not showing any telemetry despite the fact it shows u…
-
i recently bought R9M 2019 and RadioMaster TX16S MKII, followed instructions as per opentx wiki for external access mod, did the same and the module is not communicating with radio using access but wi…
-
At the moment there is no way to select what receiver you are connecting to so you cannot have more than one receiver powered on with the same bind code.
I suggest a way of using the opentx rece…
-
I configured the telemetry widget on my FrSky X20 Pro using the internal Twin module with a TWMX receiver set to F. Port. In this configuration everything worked perfectly. I then tried the same conf…
-
When choosing methods the "Bootloader" option is missing.
## Expected Behavior
Device Category: FrSky 900 MHz
Category: FrSky R9M 900MHz TX
Update via **1. Stock_BL** and 2. Wifi and 3. STLink
…
-
When choosing methods the "Bootloader" option is missing.
Expected Behavior
Device Category: FrSky 900 MHz
Category: FrSky R9M 900MHz TX
Update via 1. Stock_BL and 2. Wifi and 3. STLink
Curre…
-
Hey, interesting project - thanks for sharing.
In order to use it over here in the EU we would need this to run on 868MHz, which I assume would not be a big deal. How about LBT - did you consider imp…
-
i've switched over to edgeTX today and wanted to update the R9M module with latest and greatest ExpressLRS 2.2.0 - but there was this "no sync" error message and the module can't be updated.
-
Flashing device failed. Was attempting to update to latest ELRS firmware (3.0.0).
## Steps to Reproduce
Use taranis x-lite and latest edgeTX version (2.7.1). The module had already been successf…