-
```
What steps will reproduce the problem?
1. brows trough phpmyadmin
What is the expected output? What do you see instead?
Ports that are turned on will turn off for a short time. But enough time t…
-
```
What steps will reproduce the problem?
1. brows trough phpmyadmin
What is the expected output? What do you see instead?
Ports that are turned on will turn off for a short time. But enough time t…
-
I'm using the latest free version of FreeLSS as of writing: Version 1.22.
I recently also updated the WiringPi library.
On my Raspberry Pi 4 the lasers don't toggle and the motor doesn't do anythi…
-
```
What steps will reproduce the problem?
1. brows trough phpmyadmin
What is the expected output? What do you see instead?
Ports that are turned on will turn off for a short time. But enough time t…
-
```
What steps will reproduce the problem?
1. brows trough phpmyadmin
What is the expected output? What do you see instead?
Ports that are turned on will turn off for a short time. But enough time t…
-
I'm currently working on a MIDI sequencer project using a 16x32 RGB LED matrix in conjunction with a Raspberry Pi Zero (original 1.3). I've opted for the python bindings of this library to control the…
-
**Describe the bug**
I'm encountering an issue using rpicam-vid to encode a stream with a Raspberry Pi V3 camera on a Compute Module CM4 with my custom IO board. Here's the command I'm using:
`sudo …
-
Just wondering if we can use sphero forceband to control servo motors, leds, etc. through Raspberry pi or any microcontroller. Please suggest if anyone worked on this!
-
The module installs fine on Raspberry Pi 4, but it's not actually possible to interact with GPIO. Error message after running Get-GpioPin:
> Unable to determine hardware version. I see: Hardware …
-
```
What steps will reproduce the problem?
1. brows trough phpmyadmin
What is the expected output? What do you see instead?
Ports that are turned on will turn off for a short time. But enough time t…