-
Hi guys,
I wanted to inform you that I'm working on a simple menu system for klipper.
I already have working mockup and now I'm trying to fit it into Klippers system.
The menu structure is full…
-
Do you plan to add support for LCD + encoder? Or will control always be done through octoprint?
-
Request Z-Stack 3.x.0 coordinator firmware capable of Active mode TX at +10 dBm and +20 dBm RF output power on CC2652P and CC1352P based radios. Specifically request firmware preconfigured with 10 dBm…
Hedda updated
2 years ago
-
Hi,
I've played a bit with the new SKR mini E3 V1.2 board and liked it so far, but something was strange. After some time I've measured the head and bed temperatures, and they were too low.
My se…
-
It starts today morning. Sensors values didn't load. So rebooted HA no help.
Below is what I found in the logs:
```
This error originated from a custom integration.
Logger: custom_components.…
-
We've gotten rid of a lot of little bugs in homing and leveling lately, but the current Development code still has an obscure Z positioning problem with `G29`. So, I've narrowed down the current level…
-
# Bug Report
## What happened
New Tuya thermostatic valve was auto discovered in Zigbee2Mqtt 1.14.0 as Tuya curtain motor. Valve reports model as TS0601 which is occupied already in devices.…
-
Hi Zibous,
thanks for your great work, I was interested to have my water flow meter visible on my domoticz, but no skills to do, you did so thanks for this.
I am near to success but I have this erro…
-
[Input shaping](https://en.wikipedia.org/wiki/Input_shaping) is a control technique to create a commanding signal that cancels its own vibrations. It would be great to support it in Klipper.
The co…
-
i setted up zibgee2mqtt, everything was working fine but now my thing didn'T receive data(i have a xiaomi temp and humidity sensor and a sinope thermostat both supported) every sensor are at 0.
i …