-
### Description
Auto tune PID
### Steps to Reproduce
1.Add a menu for auto tune PID
**Expected behavior:** Do not use the host to do PID
**Actual behavior:** No possibility
#…
-
### Description
At the end of the file transfer with the MKS WIFI, the card reboot.
### Steps to Reproduce
1. The Last Configuration
2. My Configuration
[Configuration.zip](https:…
-
1.35.5
The ooze shield feature seems to take account of tool offsets for moving both heads outside the shield if they are set in the extruder settings. However if your tool offsets are set in the f…
-
### Description
On the printers with TMC and SPI ensdtops it's recomended by the firmware to reduce bump to 0mm to avoid problems, but the printer tryes anyway to get again to endstop after the…
-
Hello.
Having issue with long pauses (>10s) during printing from SD card using MKS TFT32 (firmware TFT28_32_v3.0.3) and Repetier firmware (tried both 1.0.2 and 1.0.3) on Arduino DUE board (printer…
dell9 updated
4 years ago
-
Using VScode (V1.64.2) and PIO(Core5.2.5). Marlin-bugfix-2.0.X
I cannot successfully compile if I have "#define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER" enabled or any other LCD\Controller opt…
-
### Description
### Steps to Reproduce
1. Go to print page
2. Eject Sd card
3. Then you cannot go back to the menu
4. There isno back option on the screen need to restart from swi…
-
### Description
Bed leveling isn't activating at all during prints on the last 1.3.5 firmware. It was working fine on older 1.2.2.
### Steps to Reproduce
1. Do a bed mesh and use I M420 S…
-
AZSMZ LCD + repetier 1.0.3 + Arduino Due + SMARTRAMPS -> now card is readable but is displaying only random noise.
Card was unreadable till this last fork, now serial monitor says card mounted (Card…
-
**Is your feature request related to a problem? Please describe.**
Moving to the start XY after going to first layer height Z at travel speeds causes mesh compensation to intermittently stop the trav…