-
I'm not sure if I'm doing something wrong, or this is to be expected or not.
When I use snagrecover to attempt a recovery of the stm32mp13 board I'm working with, the resulting accessible dfu alt inf…
-
Hello,
I hope this message finds you well.
I am reaching out to seek your guidance on configuring the ubxlib library for use with the LEAN_R8 device on a Linux operating system. I have successfu…
-
**Describe the issue**
I can't start a `Tauri 1.4` because when I launch it I get:
```sh
root@stm32mp1:~# dpkg -i armv7-tauri-helloworld_0.0.0_armhf.deb
Selecting previously unselected package…
-
This is a followup of the performance investigation in #5915. The summary is: OP-TEE, to run with good performance, would like to have around 384 kiB of RAM because otherwise frequent evictions of the…
-
In digging through OP-TEE I just found something that I don't fully understand. I need to be on 3.16, working on the STM32MP1 target and noticed that the platform main.c does not seem to override the …
-
Hello Tertius,
First of all, thank you for your work and developing this software.
After managing to configure the MQTT server this is what I am getting when trying to connect to my control panel.
…
-
Hi, I'm using stm32 board and rpi3 board.
I noticed that only stm32 board supports secure SRAM and pager as I looked through OPTEE codes.
But I also noticed that stm32 board is much slower than …
-
Would like to read an object file that is stored into secure storage, i.e. at /data/tee from OPTEE-OS core, and then pass it to an crypto engine block registered as drvcrypt_register_xxx, Does it need…
-
Hello, I use Optee on a stm32mp157f-dk2 board, version is the 3.16.0-stm32mp and the corresponding BSP :
- u-boot v2021.10-stm32mp
- Linux v5.15-stm32mp
All my changes are commited and built …
-
For custom application only. This would provide low cost alternative. Currently this is experimental. Only supports PoE display using 16x96 RGB with MBI5124 panels.