-
Hey team,
With the mass proliferation of cheap CC3D boards from a multitude of manufacturers, it'd be great to move away from cleanflight's Naze-centric past and be able to fully support flashing the…
fennb updated
7 years ago
-
Hi,
Using the Frsky X4R-SB with SBUS using serial rx, there is a PWM output on it for serial RSSI,
Can you please allow the RSSI_Channel to work in parallel with serial_rx?
Guess RSSI_ADC will also …
sevet updated
7 years ago
-
http://www.quantec-networks.de/shop/en/quanton/1/quanton-flight-control-rev.-1
hydra updated
7 years ago
-
As a OSD user, it would be cool if I had full Betaflight control over the OSD layouts.
While the current feature set is nice for sure, some options such as adding/removing the various horizon bars s…
-
I tryed around 10 hours to get "Servo Tilt" working with my new Sparky 2.0 and actual BF 3.0.0 RC14, but no chance. Need it for "Matek PDB 5in1" with Buzzer via AUX-Channel.
The Sparky 2.0 has 6 x ES…
-
Support for the jeti duplex telemetry protocoll would be nice to have.
-
Expanding on the DSM2/DSMX serial protocol that is already available but limited to 6 channels, I'd like to see some serial protocols available on the PPM output pin in the module bay. Specifically SU…
-
I'm putting up for discussion some thoughts I've had about the way the scheduler, pid controller and gyro update work.
These thoughts are still a "work in progress", but are sufficiently well formed …
-
I flashed the latest build onto my Sparky board. The configurator allows enabling the RSSI ADC features, but the documentation doesn't indicate which pin to send the RSSI feed from my Frsky receiver.…
-
Setup AQ32 for Tricopter from clean eeprom. PPM rx, batt monitor, FrSky sensor hub, openlog, gps, external mag.
On Vehicle tab, Vehicle type multirotor, Frame type Tricopter Y. Motor output channel…