-
I develop on Wemos Lolin32 lite board and manage to drive the TMC2208 driver. I can communicate with the driver but I can't manage to make the shaft function work. It should make the motor change dire…
-
I'm trying to setup Linear Advance / Pressure Advance.
M900 is not found and the linear advance calibration pattern lines look all the same.
I'm trying to find out if the K-Factor settings in …
-
I am trying to connect my printer via USB to windows 10 and use pronterface and I can get the printer connected but NOTHING ELSE HAPPENS. I was once able to move the print head left and right on the X…
-
I received an email asking about TMC2209 drivers in UART mode. I thought it best to move the conversation to a more public space so that the collective wisdom of the open source community can be harne…
-
Hello, just mount my MKS robin ( Firmware 2.0.8). Drivers are TMC2208.
Microstep set to 1/16 (M1 High, M2 High, M3 Low). Stepper are Nema 17, 200 Stp/ with 20 teeth pulley . The step per mm is set t…
-
Hi,
First of all, thanks for sharing this ROS stack! it really helps me alot with my robot arm.
However, I am experiencing difficulties: if use the trajectory planning, my stepper motors are m…
-
Hello all,
I am using the RPI3B in combination with Ramps 1.4 board and Klipper FW.
For different reasons I want that the PSU is alwas ON while start (e.g. the TMC2208 with UART connection needs…
-
Hi I have a SKRV1.4 turbo that made the Home correctly but when I sen to print dont respect the dimetions of the bed and I need to turn off, I try to uplod many time the firmware but still the same, I…
-
I write the firmware directly from Visual Studio via USB to the controller.
This works 10 times. After that, copying the firmware is only possible via explorer. This is again a few times, then the SD…
-
I have an skr 1.3 with TMC2208 V3.0. I only insert the jumpers on the Red UART pins.
No matter what I do I only get errors on standard commands like M122:
Send: M122
Recv: echo:Unknown command: …