-
Using latest from [https://github.com/Xinyuan-LilyGO/TTGO_TWatch_Library](https://github.com/Xinyuan-LilyGO/TTGO_TWatch_Library)
```
C:\Users\xxxx\Documents\Arduino\tic2\tic2.ino: In function 'voi…
-
how should I proceed to use it in Arduino IDE ( https://www.arduino.cc/en/software/ )
There is currently support for:
- Esp32S2 Dev Module
- ESP32S2 Native USB
- TTGO Lora32 OLED
- TTGO T1
- T…
-
Hi, on the model T-Dispay E-paper 1.02" i do not see any output for i2c such as on TTGO T-Display 1.14 Inch LCD. On LCD version there is pin 21 and 22 for I2C but on e-paper version pinout i do not se…
-
Versions that run on
- Agon Light
https://www.olimex.com/Products/Retro-Computers/AgonLight2/open-source-hardware
- ESP32-SBC-fabGL
https://www.olimex.com/Products/Retro-Computers/AgonLight2/open-…
-
I installed a 28db gain GPS antenna on my TTGO Tbeam module connected via USB to a Raspberry Pi for Stratux. After a few minutes of use after receiving a position, the TTGO shuts down. I have to reboo…
-
I purchased a TTGO T-Watch 2020 V3 last year and I completed the program I needed and it worked just fine. The last time I compiled/uploaded it using Arduino IDE 2.2.1 was on December last year.
…
-
$pio run
```
Compiling .pio/build/ttgo-lora32-v2/src/main.ino.cpp.o
In file included from /home/disaster-radio/firmware/main.ino:20:0:
config.h:29:0: warning: "OLED_SDA" redefined
#define OLED…
-
So I wonder if i have to have the battery ON/OFF switch set to on or off in order to charge the battery while powered via USB. I am not even sure if it's capable of charging a 18650 plugged into the b…
-
It would be nice if someone could add instructions on how to compile, program and upload the config via linux command line /terminal.
I assume the commands are;
1. Compile firmware and upload
`…
-
Add support for the TTGO LoRa32 V1.0 board.
V1.3 is already supported. V1.0 is not yet supported.