-
I encountered a weird problem and while most likely not related to the library, I wanted to make sure. I use the MH-Z19B with an ESP32. I already tried with an Arduino and an ESP8266 and everything wo…
-
Hi all,
It seems the oledframed lines are limited to a very small amount of characters. For normal text, this isn't so much of a problem, but using the default entity names as "Temperature" for a tem…
-
Hi,
I am using MH-Z19B CO2-sensor. I bought a second one for my bedroom and i see that it is a bit off from the one i was already using. I would like to calibrate it to 400 ppm. In the sensor code …
-
I just upgraded from 8.1.0 to 8.2.0 and now my CO2 sensor is not supported anymore. I an using several MH-Z19b sensors, which used to be type 60 (Tx) and 61 (Rx) but they don't show up anymore. Attach…
-
I've configured a MH Z19B CO2 sensor, this worked fine in 8.1.0. However in 8.2.0 i can't find options
60 MHZ Tx and 61 MHZ Rx anymore.
I've followed this page for setting up the sensor:
https:/…
nilsx updated
4 years ago
-
Hi. Thanks for the answer to [my previous question](https://github.com/AnaviTechnology/anavi-gas-detector-sw/issues/2).
Could I ask one more?
I have an ANAVI Infrared pHAT (Advanced Kit) for my Ra…
-
Hi,
is possible to get these two modules working side by side over serial communication with Arduino UNO?
I get this error:
. Toutes les fonctions n'ont pas d'unité alors que ça me semble être i…
-
may be i need to tune polling interval
maizy updated
4 years ago
-
### PROBLEM DESCRIPTION
MH-Z19b CO2 sensor (60 [Tx] and 61 [Rx] is not showing up anymore).
### REQUESTED INFORMATION
- [ ] Read the [Contributing Guide and Policy](https://github.com/arendst/Ta…