-
is it possible to change the hdmi resolution of gx66058 board to 800x480.
I have tried it here, https://github.com/ric96/addons-linux/commit/2601d689426823256d368611bee65bcb0f6dda86 but it only works…
ric96 updated
5 years ago
-
Hello has anyone chorus rf with ESP8285 - ESP-M3??? Which FW did you flash in the wifi? An which program for flash did you use ?
-
I've managed to get my CX-10 to bind via nrf24l01 only at one point. It connected for a few times after the initial binding then I put it away. Took it out the next day and was no longer able to get…
-
Pictures of Tuya TYGWZ-01 / TuyaGo TYGWZ01 and links to official product page is missing project website:
https://paulbanks.org/projects/lidl-zigbee/
Suggest mention "**_Tuya TYGWZ-01 (also know…
Hedda updated
11 months ago
-
My existing hot water tank thermostat is hard wired to the boiler system. There has been some damage to the wiring that is disruptive to repair, so I am looking at a wireless system that integrates wi…
dunxd updated
2 years ago
-
I would like to see a more detailed schematic. I have several questions:
1. What is the blue LED for? (I think it is a LIPO charging status of some sort)
2. I found a limited schematic that shows …
-
After hours of trial and error, I have finally solved the bug issues with updating the firmware. Until about December 2019, there were bugs within V2.1 that did not allow settings to be changed. After…
-
Trying to flash a board that has one dead motor (even after replacement), I figured I have nothing to lose before I dump it.
Getting this on the unlock step:
```bash
$ openocd -f /usr/share/openo…
-
Hi,
I’m using the code example given for a relay, the relay is switched on using LOW and switched off using HIGH.
I’ve changed these in the turn on and turn off sections of the code.
When connectin…
-
Hello :)
I am coming from iNav and noticed BetaFlight does not support the Naza GPS protocol (which uses one UART for both "GPS and Mag") which I think is kind of sad (already using SoftSerial for …