-
Hello,
Can I ask You, if is possible configure BIGTREETECH-SKR board to 4 Axis, like XYZ and C (rotary).
Thanks
-
https://github.com/bigtreetech/BIGTREETECH-TMC2209-V1.2/blob/master/manual/TMC2209-V1.2-manual.pdf
https://github.com/bigtreetech/BIGTREETECH-TMC2209-V1.2/blob/master/Schematic/TMC2209-V1.2.pdf
The …
-
file: "**BTT TFT35-E3 V3.0-3D.step**" dated 2022-08-23”
The LCD, JST connectors and many other components is missing
**I tried:**
Fusion 360
Freecad
viewer.autodesk.com
There are two step fi…
-
As the title suggests, many files, including mmu_software.cfg, mmu_form_tip.cfg and mmu_cut_tip.cfg, are read only since the update to 2.5.1. Additionally [save_variables] was missing in mmu_software.…
-
Can you implement a webcam stream on the screen?
If so, then make a horizontal bar of the print status.
![K-Touch illustration](https://github.com/user-attachments/assets/dc767488-50b6-4d20-8590-a5d…
-
**BTT PAD7 , with CB1 board,**
- installed CB1_Debian11_minimal_kernel5.16_20230303 - ok
- installed octoprint - ok
**tried to install octodash,**
can acces remotely, so system operates, ssh -…
-
See install guide: [Klipper Installation](https://www.klipper3d.org/Installation.html).
It looks like I would need to use the [Ender 3 S1 config](https://github.com/Klipper3d/klipper/blob/master/co…
-
Dear all, Finally, after some mistakes, and trials, this is my contribution to schemes and connections, connector marked as 3, is NOT an Input, connector number 3 is an OUTPUT, you could use this sign…
-
I downloaded BIGTREETECH-SKR-E3-DIP-V1.0-master.zip and unzipped it in VSC. Checked all the changes needed and noted to change default_envs in platformio.ini to STM32F103RC_btt. When compiling got the…
-
### Description
CR-Touch doesnt Auto home properly using the marlin firmware.
I already tried adjusting some settings in the firmware.
defining USE_PROBE_FOR_Z_HOMING and BLTouchv
### S…
Loifu updated
6 months ago