-
I thought initially it was a TFT problem, but the odds of 3 different TFTs failing to work with the SKR V1.3 board is highly unusual. And from what I have found on the forums, between the BTT SKRV1.3/…
-
It would be good to get documentation for Mini12864 display.
Minimum needed is pinout and corresponding Marlin settings for it.
-
Hi,
which additional hardware is compatible?
1. Can I use my original Ender 3 LCD?
2. Is it compatible to the [BTT TFT35 E3 V3.0 Touch Screen](https://www.aliexpress.com/item/4000365519309.html…
-
## Issue
* On the `output-only-wc` [branch](https://github.com/RaspberryPiFoundation/editor-ui/pull/782), you could specify an assets identifier - this would load just the assets from the given identi…
-
I've been talking with @Fragmon a bit about their Kobra work today and an interesting find came up: Bltouch probes don't work with the clock speed set to 200mhz. Flashing a 200mhz config shows a 168mh…
-
Good morning, everyone,
Does BTT check its firmware before offering it, it's incredible there's never a .bin that works properly.
Following the replacement of my Mini E3 (TMC X HS) I wanted to try t…
-
Am I the only one for whom this isn't working with BTT? The folders are being synced via Dropbox alright, but each of my machines appears to use a unique filename so the settings are not synced betwee…
-
Upgrade the CB1 image to Debian 12 Bookwoom to allow use of /dev/serial/by-id/
-
Самого доброго времени суток, выражаю благодарность за ваш труб в создании такой прошивки.
Проблема:
1)устанавливаю готовую прошивку, при включении срабатывает проверка bluetouch, ставлю autohome,…
-
Hello all,
I always had my problems in reliability using the old ERCF 1.1 design. It heavily improved with ERCF 2 encoder - but is far away from being stable.
So I am wondering, if it would be pos…