-
If a request from a single IP continuously hits the same request on mirrorlist its cache will remain indefinitely. By default the cache for an IP expires after an hour but hits within this window wil…
-
after crack the firmware, i can get the http access without any authentication. Will it be some of loop hole to hacker to hack my camera to be part of the DDOS attack zombie?
And as we need to use …
-
### What is the issue?
My exit node was running Ubuntu 20.04 and working. I recently did a fresh install of Ubuntu 22.04 on that device, installed Tailscale, set it up as an exit node following the d…
-
Reoccuring, no internet access, but internet seem fine from other software.
ukuu v18.5.1
Distribution: Linux Mint 18.3 Sylvia
Architecture: amd64
Running kernel: 4.16.11-041611-generic
Kernel v…
-
Re: forum request - Forums have been down for over a week, I assume this is an outdated message?
**Minecraft Version:** 1.20.4
**Forge Version:** 49.0.30
**Logs:** https://gist.github…
-
Hello! I have been using this program for the last three months without issue. Now, when I try to use it, my data usage shows as Hotspot on my plan (and thus is throttled once I've gone over my cap). …
-
**Describe the problem**
Client A (Laptop) wants to connect to Client B (Server). Client B has a public IP, so netbird selects Direct Connection. However, ufw blocks the port (**51820** as found in `…
-
### Contact Details
_No response_
### What happened?
### Issue
When trying to connect via the Windows 11 client, the following error always occurs (different variations of this error occur, e.g.…
-
### The Feature
I would like to read the water meter at remote locations, since I am behind CGNAT everywhere, I would like to send the results to my web server with a typical LAMP stack.
For this…
-
> Note: pwnat defaults source and destination ports to 2222.
Most NAT would change source port to another number, while by monitoring data out NAT we can watch that. So to get the real source port …