-
Should be very similar to https://github.com/ddccontrol/ddccontrol-db/pull/6 (CC @feuerrot @dimaqq) because this model U2713H (on the device it says U2713H**b** but to `nvidia-settings` over DisplayPo…
-
### Introduction
Textbook examples for simulink and arduino - hardware experiments
Reference:
Simulink 与低成本硬件及机电一体化
丁亦农 Joshua.L.Hurst
清华大学出版社
本书以DC motor的simulink-arduino实时仿真模拟为例，介绍低成本设备机电一体…
-
Hello,
I'm using Grbl845Mega2560 and when I change the feed rate (eg. G91 G1 F1000 C180 and G91 G1 F20000 C180 ) than C-axis feed rate is still the same. Is it possible to increase the feed rate some…
-
Hi, thanks for you work
I want to use **vapix_control** method with **speed** para, However, the camera does not move, maybe the problem is http in **vapix_control.py** file , but how do I change i…
-
I have been running FF-Remote-Control on 40 instances of Firefox on 33 different Linux computers. These have been running as a digital signage system and they are up 24/7. It works GREAT almost all …
-
Dostálek, L. & Kabelová, A. _Understanding TCP/IP: A Clear and Comprehensive Guide to TCP/IP Protocols_. 2006.
Reading list: https://blog.syafiqhadzir.dev/Readings
### Milestones
- [ ] **Intr…
-
Hello there!
First of all, thank you very much for this wonderful little tool! :-)
I have a question about the speed.
I have version 0.4.4 running, but the speed is quite low (1sec).
Especial…
-
```
ddccontrol version 0.4.4
Copyright 2004-2005 Oleg I. Vdovikin (oleg@cs.msu.su)
Copyright 2004-2006 Nicolas Boichat (nicolas@boichat.ch)
This program comes with ABSOLUTELY NO WARRANTY.
You may…
-
### Checklist
- [X] I have updated the integration to the latest version available
- [X] I have checked if the problem is already reported
### The problem
Hello! I recently started getting t…
-
For the landing page, my proposal is the following:
@CarloQMontangero @scatenag @emulatingkat
TAUmus (1972-1977)
TAUmus is computer music software developed during the 70’s, first at IEI and then…