-
I apologize for the my basic question; I'm new to this.
I've found the rc-switch library to be highly effective when working with 433mhz remotes. But now I want to explore other 433mhz products li…
-
Hello, after setting the correct profile (Digoo DG-SP202) and clicking Save, the device rebooted and right after hearing the two relays, it blew the fuse in the fuse box and apparently also in itself.…
-
Hello,
I propose adding to instructions that it's necessary to unplug any devices from the device that is being flashed. Seems obvious but it's easy to forget, especially if there are other warning…
-
Nothing happens....:
I connect my phone to the newly created vtrust-flash AP, I set the plug to start flashing, I press Enter.... and all I get are dots. Below are the log files.
smarthack web
…
-
Starting Nmap 6.47 ( http://nmap.org ) at 2019-05-24 10:32 CEST
Nmap scan report for 192.168.1.26
Host is up (0.042s latency).
Not shown: 994 closed ports
PORT STATE SERVICE VERSION
21/t…
-
I tried Tuya-convert with a brand new Digoo NX-SP202 dual socket but it did not connect to fake AP.
After some sniffing, I found out my socket is attemting to connect to "tuya_mdev_test2".
Then …
alfem updated
4 years ago
-
Please take a few minutes to complete the requested information below. Our ability to provide assistance is greatly hampered without it. The details requested potenti…
-
```
What steps will reproduce the problem?
1. I would like that if I could give you support portable console and console
pokemini Cdi since the source codes are in the page of the emulator that is
v…
-
I have a problem with the rf bridge of sonoff, send by mqtt the svalue only when the emitter stops emitting. for example, with the emitter of four buttons when I stop pressing send svalue by mqtt. Thi…
-
### PROBLEM DESCRIPTION
My digoo sp-202 was working perfect and power monitoring also working perfect but after reset itself by the power cycle reset. Power monitoring not working at all. I am us…