-
Is there any possibility to use slic3rs function for octoprint for uploading files directly to sd card?
-
Hello Gina.
I am with Prusa Research. We would like to display IP address assigned to the Raspberry PI by a DNS directly on the 3D printer display. We did that before with the Toshiba Flash Air as …
-
### Version
version_2.1.0-rc-5-gfec111302
wxWidgets v3.0.4
### Operating system type + version
Arch Linux
* -DSLIC3R_STATIC=0
* -DSLIC3R_FHS=1
* -DSLIC3R_WX_STABLE=1
* -DSLIC3R_GTK=3
* …
-
**Printer type**
MK3S
**Printer firmware version**
3.9.0-3421
**MMU Upgrade**
MMU2S
**MMU upgrade firmware version**
1.0.6
**SD card or USB/Octoprint**
Print from SD Card, Octoprint …
-
Can't find any other reports of this since 2012, so here goes: M30 fails in marlin 2.0 on Re-arm(an LPC1768-based board), and is missing newline on M30 fail. Serial monitor must be reconnected, and SD…
-
### Version
PrusaSlicer 2.2.0+
### Operating system type + version
MacOS High Sierra 10.13.6
### 3D printer brand / version + firmware version (if known)
Prusa MK3S
### Behavior
PrusaSlic…
-
@perrada69 :
Can't delete file with leading dot in the name
**Steps to reproduce:**
1. Create file with leading dot in the name:
```.test```
2. Cannot delete the *.test* file from CalmCommand…
-
Hi Prusa Team,
hereby i would like to ask you for adding support for Repetier-Server to upload GCode from slicer directly to the print server. You already support OctoPrint, Duet, FlashAir, AstroBox.…
-
Uploads are extremely slow, it would make more sense to use an external SD card for uploads instead of going through AUX or TFT RX/TX. Or add support for FTP or just a URL to the gcode (dropbox, goog…
-
As we know, Marlin lists gcode file from sd in the old DOS 8.3 format. Newer marlin versions should support the M33 command for returning the "original" filename insted of the short version.
For a …