-
The graph looks terrible.
Why is it so chewed? How to smooth it out?
The top graph is lovelace-plotly-graph-card and the bottom graph is the original graph which looks great as any normal graph sh…
man55 updated
2 months ago
-
Look into lowering component lock time.
-
Hi,
I been monitoring my JKBMS and i noticed for a long while that the charging and discharging current goes to to the oposite number after 32amps.
So if im charging it shows for exemple 20amps …
-
Hi Michael.
Its not a really issue just only a newbie question. Your sketch is awesome!
Im curious It would be possible to get/set more data as described at https://github.com/victronenergy/venus/w…
-
Hi, I have JKBMS JK_PB1A16S15P
Hardware version V15A
Software V15.27
I cannot read any data from it.
```
$ mpp-solar -p C8:47:80:11:C6:19 -P JK04 -D
2024-07-17 20:05:09,605:INFO:__init__:ma…
-
### Describe the bug
The mapping between the labels on the physical temperature sensors and the IDs reported by dbus-serialbattery is wrong.
On the BMS balancer wiring loom (in my case, PB2A16S20P…
-
Hi, thank you for your great project and support!
I'm a Software Engineer, and I have a JK BMS (PB-2A16S15P - HW: 15.XA, SW: 15.10) with a faulty RS485-1 (right besides CAN port), which makes me unab…
-
I have BMS JK-PBx working via CAN bus with Victron directly. But I would test your solution.
My config is multi-bms_JK-PB_RS485_mode2.yaml. And my device is this one:
![image](https://github.com/u…
-
Hi,
In my setup I have two JK BMS using dbus-serialbattery driver and a CAN-BUS BMS for which I do not need dbus-serialbattery as it is directly recognized in Cerbo GX. Does dbus-aggregate-batterie…
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Current Behavior
I do not consume electricity from the network, but it shows that there is consumption
![IMG_…