-
Printer type - MK4
Printer firmware version - 5.0
MMU upgrade - No MMU
MMU upgrade firmware version - No MMU
Does this with both SD card and USB/Octoprint
Describe the bug
Nozzle cleaning fa…
-
Printer - XL 5TH
Firmware - 6.0.0
After a week or so printing with the alpha firmware, I started to get a nozzle cleaning error on TH1.
After a successful print, on the next print job, the p…
-
### Subject of the issue
I can't get my loadcell to work with openlog artemis. Not sure if its due to the load cell reporting negative raw values, but I'm just getting empty entries (not zeros in co…
-
Stepper:
PUL : IO23
DIR : IO22
TX : IO26
RX : IO27
ADC:
DRDY : IO19
DOUT : IO18
SCLK : IO15
DIN : IO13
CS : IO21
LOADCELL 1: A0/A1
LOADCELL 2: A2/A3
LOADCELL 3: A4/A5
Onboard LED : IO2
-
I'm using this code to read from my HX711/load sensor:
```
use esp_idf_svc::hal::{delay, gpio::PinDriver, peripherals::Peripherals};
use loadcell::{hx711::HX711, LoadCell};
fn main() {
es…
-
Hi sir tatobari,
Do you have some way to get the first initial mass from the code?
like.. after the Tare where the value is 0, then you suddenly lumped in a 3kg you get to record and save the 3kg …
-
So the library works great for one amplifier and load cell. But what would I need to change if I wanted to set up to 2 load cell and amplifiers?
-
const int HX711_dout = 4; // mcu > HX711 dout pin
const int HX711_sck = 23; // mcu > HX711 sck pin
I tried these with out the const keyword. I tried int, uint8_t and it doesnt works
loadCell.g…
-
This plugin doesn't work for me. Tried two scale setups with the green board. Under current reading NaN is reported and nothing can be calibrated.
-
The default printer start gcode for the XL 5T has this line
```
M109 T{initial_tool} S{((filament_notes[initial_tool]=~/.*HT_MBL10.*/) ? (first_layer_temperature[initial_tool] - 10) : (filament_type…