-
nandpath="/dev/mmcblk1p1"
Causes only about 4 MB to dump.
It has to be nandpath="/dev/mmcblk1"
-
hi @bkerler,
i'm trying to generate rawprogram0.xml for a device instead of do it manually.
This module is using NAND, but when you upload the programmer and using `--genxml` flag, it throws this …
-
```
What steps will reproduce the problem?
1.Download OMAP35X.tar.gz in TI_Android_DevKit 02_02_00 and prepare SD Card
2.Set SW4 as ON(1)-OFF-OFF-ON-ON-OFF-OFF-OFF
3.Power ON
What is the expected outp…
-
```
What steps will reproduce the problem?
1.Download OMAP35X.tar.gz in TI_Android_DevKit 02_02_00 and prepare SD Card
2.Set SW4 as ON(1)-OFF-OFF-ON-ON-OFF-OFF-OFF
3.Power ON
What is the expected outp…
-
```
What steps will reproduce the problem?
1.Download OMAP35X.tar.gz in TI_Android_DevKit 02_02_00 and prepare SD Card
2.Set SW4 as ON(1)-OFF-OFF-ON-ON-OFF-OFF-OFF
3.Power ON
What is the expected outp…
-
```
What steps will reproduce the problem?
1.Download OMAP35X.tar.gz in TI_Android_DevKit 02_02_00 and prepare SD Card
2.Set SW4 as ON(1)-OFF-OFF-ON-ON-OFF-OFF-OFF
3.Power ON
What is the expected outp…
-
### Answers checklist.
- [X] I have read the documentation of the component in question and the issue is not addressed there.
- [X] I have searched the issue tracker for a similar issue and not found…
-
Hello! Thank you for publishing Dhara.
I have been playing with it and wanted to share some performance numbers. I am using a NAND Flash chip on an embedded system. When I use my raw nand driver, I…
-
看到你也在研究 IPQ5018，我最近也在搞这个，但我水平实在太业余，网上找到一些源码算是编译出来了，但因为试的机子是 PZ-L8，使用的是 ESMT F50D1G41LB 闪存，启动时就识别不正常，前一句还正常识别nand: device found, Manufacturer ID: 0xa1, Chip ID: 0xa5，后面就是nand: unknown nand 2gib 1,8v 8-…
-
I found that winbond flash chips supported by flashrom are all nor based. Can I add nand based serial flash chips?
Thanks & Regards
Asmita